Introducing “PEGOKUR”

Packaging: 25 Kg bags

Colors: Grey and White

Concrete masonry.
Cement mortar bed.
Brick Masonry.

Shelf Life

Factory sealed containers of this product are guaranteed to be of first quality for 9 month if stored off the ground in a dry area.

Cautions

• Contains Portland cement,  silica sand and polymers.
• May irritate eyes and skin.
• Avoid contact with eyes or prolonged contact with skin. In case of contact, flush thoroughly with water.
• Do not take internally. Avoid breathing dust. Wear a respirator in dusty areas.
• Keep out of reach of children.
• Protect finished work until fully cured
  

TECHNICAL DATA  Working Properties (At 23ºC)

• Wet density1.70 gm/cm³.
• Open time  40 minutes.
• Pot life 2 Hrs.
• Time to traffic 48 Hrs.

Note: Specifications subject to change without notification. Results shown are typical but reflect test procedures used. Actual field performance will depend on installation methods and site conditions.

INSTALLATION

Preparation

All surfaces should be between 5º C to 38º C and structurally sound, clean and free of all dirt, oil, grease, loose peeling paint, laitance, concrete sealers or curing compounds. Rough or uneven concrete surfaces should be made smooth with Portland Cement under layment to provide a better finish. Dry, dusty concrete slabs or masonry should be dampened and excess water swept off. Installation may be made on a damp surface.

Mixing

Place clean potable water into a clean pail. Add PEGOKUR powder. Use approximately 5 – 5.5 Liters of water for 25 Kg bag of powder.

Mix by hand or with a slow speed mixer to a smooth trowelable consistency. Allow mortar to slake for 5 –10 minutes. 

Adjust consistency if necessary. Remix and apply with the proper sized notched trowel.

Application
Apply mortar to the substrate with the flat side of the trowel, pressing firmly to work into surface. Comb on additional mortar with the notched side.

Note: Use the proper sized notched trowel to insure full bedding of the tile. Spread as much mortar as can be covered with tile in 15-20 minutes. Back butter large tiles (>12”x12”) to provide full bedding and firm support.

Place tiles into wet sticky mortar and beat in using a beating block and rubber mallet to imbed tile and adjust level. Check mortar for complete coverage by periodically removing a tile and inspecting bedding mortar transfer onto back of tile. If mortar is skinned over (not sticky), remove and replace with fresh mortar.

Cleaning

Clean tools and tile work with water while mortar is fresh.

Warranty

 If this product prove to
be a defective material, the manufacturer warrants that it will replace the same or refund
the purchase price of the goods. THIS WARRANTY IS IN
PLACE OF ALL OTHER WARRANTS EXPRESS OR
IMPLIED. The suitability of a
product for an intended use shall be solely up to the user.
Manufacturer assumes no liability for consequential
damages. Its liability shall in no event exceed the purchase
price of the materials supplied by it. No person has the
authority to change these items and there are no warranties
except herein stated.